I am so confused that why I can’t find on how to do this…

  1. Offline the failing (but still working disk) from the LVM RAID1 side
  2. Physically remove it from the system
  3. Put in new disk
  4. Tell LVM RAID1 to use the newly installed disk

I do not have space in a dual caddy to put in the “to be replaced” disk for the --replace parameter to work. So how do I flipping tell LVM that I want to offline the disk that I wanna remove? Then online the new disk??

  • DBGamerOP
    link
    fedilink
    arrow-up
    1
    ·
    3 years ago

    I am sorry but I am lost on what you means. I gotten a $30 5.25" Dual Hot Swappable 2.5" bays which each of the drives connected through the SATA interface (you plug the respected SATA cables in each bays’ end and the drives connections are literally “clicks into place”).

    So I thought if the drives are on standby “hence I assume are therefore not spinning up/down” then I thought it safe to pulls them out. Since I thought they would not be doing anything if they are simply on standby.

    • Helix
      link
      fedilink
      arrow-up
      2
      ·
      3 years ago

      Dual Hot Swappable 2.5" bays which each of the drives connected through the SATA interface (you plug the respected SATA cables in each bays’ end and the drives connections are literally “clicks into place”).

      Yeah, but if your mainboard doesn’t support hot swap on the ports they’re connected to, you can’t hot swap them. Similarly, if your disks themselves don’t support hot swap, you can’t hot swap them.

      In my experience, swapping disks while the PC is booted should only be done if you’re absolutely certain both the mainboard and the disk support hot swapping properly, else you may damage the disk. Especially consumer-grade disks are susceptible to failures in this way.

      So I thought if the drives are on standby “hence I assume are therefore not spinning up/down” then I thought it safe to pulls them out.

      Not really. Only if they support hot swapping and your motherboard does as well. Many do, some don’t.

      I thought they would not be doing anything if they are simply on standby.

      Being on standby may simply mean they have parked their r/w arms and are still spinning.

      In one of your other threads, you posted SMART information which shows “Power-off Retract Count” as 72, which means there were 72 instances where the drive didn’t properly shut down or lost power unexpectedly.

      For comparison, my 4 year old WD Red HDD has >33000h of usage and only a power-off retract count of 14.

      • DBGamerOP
        link
        fedilink
        arrow-up
        1
        ·
        3 years ago

        That’s understandable to me now, thank you very much for explaining all of this to me so I am able to becomes aware and able to understand everything now. :)