I am currently looking into High Availability for my work setup. I am having some problems understanding how to achive that. I have two servers, one running libvirt and a couple VM, the other one nothing much yet.
To achieve HA with keepalived, I would have to setup the exact same VMs under the second server, right? If that’s the case, how would I make sure that the “mirrors” stay equal, If for example the master goes down, the backup takes over, some changes are made in a DB and the master knows nothing about these changes.
Maybe I misunderstood keepalived so far, can somebody provide me with an example setup or hints on how to achieve what I want to do?
Kind Regards
g7s
It’s been a few years since I used keepalived so my knowledge might be outdated.
You are correct that the VMs should be in different servers. To test around you can set up on the same, but this shouldn’t be done in production environments, if you lose the host, you lose the service.
Keepalived will make sure your service is available in an IP. To say, you have two (it can be configured for more than two) servers with (A) 192.168.0.2 and (B) 192.168.0.3 which provide the service you want to provide. With Keepalived you’ll configure a common IP for both of them, let’s say 192.168.0.4
While working, server A will be available at 192.168.0.2 and 192.168.0.4 while server B will be available at 192.168.0.3. If server A fails keepalived will “move” 192.168.0.4 to server B, so 192.168.0.2 will not be available and server B will be available at 192.168.0.3 and 192.168.0.4.
No matter which server is up / primary, your service will always be available at 192.168.0.4
For the mirroring part, you need to solve it in another step outside from keepalived. For example, MariaDB provides multimaster replication “out of the box” with galera (the recommendation is at least 3 nodes)
For files, depending on your filesystem you should have to rsync, use some shared units, distribute filesystem (Ceph), …
Thank you for the explanation. I might look into heartbeat, as suggested by @arbiter. I understand now, that keepalived is only working on an IP layer, and not helping me with mirroring my actual VM’s. For that I will look into other technologies.