[[ solved ]]

I have a stack of SATA hard drives that I need to erase.

I have a USB drive dock, a box that a drive can be set into that connects to my computer via USB-3.

I am using DD to write zeros to the raw device, in this case, /dev/sdf.

No matter the actual size of the drive dd stops at about 3 to 7 gb. These are 300 gb to 3 TB drives.

I am not mounting the drives, but I do ensure they are visible to the system with lsblk. To change drives I turn off the dock. The drive then disappears from lsblk. When I insert a different drive and turn the dock back on again /dev/sdf re-appears.

Are all my drives bad? If they are I will need to have them “professionally” destroyed at about $25 a drive.

Next Update –

I started with a USB to SATA adapter that looked like a small box with a SATA connector on one edge and a USB cable coming out of one side, it had a power supply that connected to the small box - everything out in the open.

Then I went to a drive toaster - a dock where you slot the drive into a hole in the top of the dock, again powered and USB-3 (blue connector)

As of this update I have opened my USB-3 external drive and removed it’s native drive and put in one of the 1TB drives I wish to erase. I also switched to my production laptop. Now I have issued a dd command and it has written so far 28GB from /dev/urandom.

I think this will finally work. - I am marking this solved.

  • Dr_Willis@sh.itjust.works
    2·
    1 year ago

    using dd to zero a drive - is not a secure way to delete the data. It could potentially be recovered.

    You mount filesystems, but you are accessing the device directly, so you are not using the filesystem, so no need to mount.

    As the other comment mentions, it sounds like a controler issue. monitor the output of sudo dmesg -w as you are doing the work on them.

    need to have them “professionally” destroyed at about $25 a drive.

    A Hammer is about $5 and will destroy them. :)

    • dack@sh.itjust.works
      1·
      1 year ago

      For the vast majority of people, writing zeroes to the disk is good enough. Even nation states and other advanced attackers would need a good amount of luck to get anything useful off a single pass zeroed HDD.

      If you really need more than that, then there are various standards and recommendations for multiple passes of random/zeros/ones. Or just go the destructive route.

      Of course SSDs are a totally different scenario. Writing zeroes is not sufficient or recommended for those. Generally, the secure erase command is the best way. However, this requires trusting that the firmware does that properly. If you don’t trust the firmware, destructive is the only option.