Then I’ll do it for you: Yes, that thing looks scary, but it’s only the slat. The plane can fly without it, but the landing will have to be done at slightly higher than normal speed. The wing itself is made from much stronger material.
I’m curious about the cause, though. Could have been initiated by a bird strike.
The issue I have with this isn’t the slat itself, but that the plane took off with this entirely unmanaged. Tape is fine, even missing bolts are fine, this is not something that you’re just allowed to ignore. Deferred maintenance is never a good idea.
I didn’t see anything in the linked article about it looking like that before takeoff, though? I’m having a hard time believing that the pilot would just think “meh, it’s fine” if it was discovered during the preflight walk-around.
Passengers on the flight said they heard and felt the vibration caused by turbulence immediately during the takeoff sequence, too soon for a bird strike. Bird strikes also don’t usually look like this.
cw: animal death
They’re usually either going to bounce off and leave a pink splatter or smear, or will be heavy enough that they caused more substantial damage at a single point, along with a red smear.
We can’t rule out a bird strike without an investigation, but this doesn’t seem likely to me.
Well if you used the slower speed the plane really will fall out of the sky. Slats and flaps generate extra lift to enable taking off and landing at slower speeds and therefore using shorter runways.
The slat could have been hit by something, so we don’t know about the falling apart part; failure of the slat isn’t going to down the plane but it will ground it.
Then I’ll do it for you: Yes, that thing looks scary, but it’s only the slat. The plane can fly without it, but the landing will have to be done at slightly higher than normal speed. The wing itself is made from much stronger material.
I’m curious about the cause, though. Could have been initiated by a bird strike.
The issue I have with this isn’t the slat itself, but that the plane took off with this entirely unmanaged. Tape is fine, even missing bolts are fine, this is not something that you’re just allowed to ignore. Deferred maintenance is never a good idea.
I didn’t see anything in the linked article about it looking like that before takeoff, though? I’m having a hard time believing that the pilot would just think “meh, it’s fine” if it was discovered during the preflight walk-around.
There is no way they took off with it looking like this. If you did it could cost you your license depending on the mood the local FAA office is in.
deleted by creator
That doesn’t actually appear to be what happened.
deleted by creator
Passengers on the flight said they heard and felt the vibration caused by turbulence immediately during the takeoff sequence, too soon for a bird strike. Bird strikes also don’t usually look like this.
cw: animal death
They’re usually either going to bounce off and leave a pink splatter or smear, or will be heavy enough that they caused more substantial damage at a single point, along with a red smear.
We can’t rule out a bird strike without an investigation, but this doesn’t seem likely to me.
deleted by creator
I’m not sure I’d want to be doing a faster than normal landing in a plane that’s already showing signs of falling apart, but I am reassured.
Well if you used the slower speed the plane really will fall out of the sky. Slats and flaps generate extra lift to enable taking off and landing at slower speeds and therefore using shorter runways.
The slat could have been hit by something, so we don’t know about the falling apart part; failure of the slat isn’t going to down the plane but it will ground it.