• RentlarOP
    link
    fedilink
    141 month ago

    TL:DW; Trains have better per-rider capex and opex costs. Despite train sets being more expensive than buses and station/railway infrastructure that might cost more than busways, trains and railway infrastructure last far longer, require fewer drivers or sometimes none per vehicle, structures, tunnels and bridges are relatively fixed costs that don’t need to be significantly more to support more riders.

    • @HenriVolney@sh.itjust.works
      link
      fedilink
      41 month ago

      If I remember correctly, bus rapid transit, when fully implemented, can have better value for cities, especially those in poorer countries where the upfront investment for large infrastructure is too high. It can move a lot of people with large articulated buses that run at very high frequency. They don’t need tracks and allow the line to run even if one bus is down (a major drawback for rail transportation). Anyway, always good to spread the very real advantages of urban rail transportation.

      • RentlarOP
        link
        fedilink
        41 month ago

        Yes. Absolutely there are some good advantages, and no doubt the upfront costs are signficant. The argument in this video is that over the life of a subway, train or LRT service that since buses have to be replaced many times over one train’s lifespan.

    • LovesTha🥧
      link
      fedilink
      11 month ago

      @Rentlar are train tunnels cheaper than bus tunnels? The ones that get built tend to be because single lane traffic tunnels are rare (and dangerous) and the are a larger bore than a train tunnel.

      • RentlarOP
        link
        fedilink
        31 month ago

        The requirements for a train tunnel are different than for a bus tunnel, which “may” be cheaper depending on what you compare to. Usually a bus tunnel will need to also accommodate diesel and gas(petrol) burning vehicles which increases ventilation requirements significantly. A train tunnel might be electric only or have diesel engines running through it. A train tunnel will need to meet the accepted standard rail vehicle envelope of the region or the isolated rapid transit system, same with road vehicles, but since the latter includes taller trucks, the height clearance would be necessarily higher than buses.

        Single line width rail tunnels are used, but dual lane tunnels are the choice for some new passenger rail projects for the speed of being able to bore them even if it is more expensive.

          • RentlarOP
            link
            fedilink
            1
            edit-2
            1 month ago

            Kinda. They are about the same speed, comparing the Scarborough Subway single TBM vs. the Eglinton Crosstown are both purpoted to travel 10m to 15m per day. Even if the speed of the smaller TBMs is a bit faster, the design of having one tunnel vs. two tunnels would be different. Costs of tunneling might vary greatly by project, accounting for each locations’ ground conditions and existing infrastructure to navigate around. So I concede that I could be wrong about the price in the general case when comparing 1 big vs. 2 small machines.