Snap the bolt before you ever strip the screw. I hate regular alan keys, torx should be the default everywhere. I did lose too many torx bits when impacting though
I have no idea how you managed to overtorque a torx honestly. Especially since you say alan key doesn’t do that. Alan keys are okay-ish when used on M5 and more. But stripping smaller screws than that is so common it’s almost useless. Also good alan keys have a small ball bearing on them on the ball side which lets you hold the screw on it or “free spin” as you call it.
After he did it the first time, I linked him a nice Wiha set. He stripped more a week later because he hadn’t gotten around to buying the screwdrivers. (iFixit is great too)
Torx bolts in the T40+ size that are exposed to moisture are impossible to remove. I’ve just moved to welding a nut on before I even go through the trial of breaking off half a dozen bits and then doing the same.
deleted by creator
Torx gang reporting in 👌👍
Snap the bolt before you ever strip the screw. I hate regular alan keys, torx should be the default everywhere. I did lose too many torx bits when impacting though
deleted by creator
I have no idea how you managed to overtorque a torx honestly. Especially since you say alan key doesn’t do that. Alan keys are okay-ish when used on M5 and more. But stripping smaller screws than that is so common it’s almost useless. Also good alan keys have a small ball bearing on them on the ball side which lets you hold the screw on it or “free spin” as you call it.
deleted by creator
Try a Wera, that’s what I run now. Expensive but worth it. Got both alan, alan imperial and torx.
Fuck that Alan guy
One of the IT guys at my work is really good at stripping torx, but that’s because he uses a driver a couple sizes too small.
That’s just… Wow.
the sizes are definetley hard to figure out, but the “if it wiggles, it’s too small” rule applies to torx as well.
He needs to get himself an I fixit kit.
After he did it the first time, I linked him a nice Wiha set. He stripped more a week later because he hadn’t gotten around to buying the screwdrivers. (iFixit is great too)
Why doesn’t he just use some kind of drill bit to ream out the hole? Seems easier and gets there quicker.
Torx bolts in the T40+ size that are exposed to moisture are impossible to remove. I’ve just moved to welding a nut on before I even go through the trial of breaking off half a dozen bits and then doing the same.