The experimental mat has been out for about a week now, but extremely high winds during a storm last night pulled up a corner of the mat spilling out the contents.
Luckily the majority of the plants were able to be saved, so we have one empty spot now.
I added some weights to the four corners to hopefully prevent this from happening again.
This is why we’re experimenting! Learning what works and what doesn’t with the setup.
You must log in or register to comment.
Post cleanup picture, lots of silt was stirred up while I was reorganizing and tying off new lines.
i did not expect this level of action ngl
Neither did we!
Original post.
https://lemmy.world/post/15830343Dang ol nature man, tell you whut
How uv stable is the foam? Not much can survive being in the sun all day without degrading
Yes, this type of foam is used for docks, boats, sports, and more importantly… this is what the original papers used. All of the parts are rated for water, temperature, and UV resistance.
Removed by mod
You saw, but did not read my original post.
I did. But since you’re assuming I didn’t why don’t you go ahead and tell me what you assumed I missed.
Ah, bummer. But like you said, this is why we experiment. Negative results are still results!
If you only share perfection people don’t see what some of the pitfalls could be! I love seeing results, no matter which way they fall.
I didn’t look very close at the growing medium, so the “spill” looked like deer poops and I imagined a deer was tricked onto water and literally all the shit was scared out of 'em when they fell in
Happy to see your garden was salvaged and improved, but a little sad that my deer theory wasn’t accurate
The growing medium is LECA, but we did catch a deer nearby, so I guess it’s POSSIBLE it was deer inflicted.
The past few days have taught me it’s a lot harder to get floating projects right than I thought it would be.
Cool experiment. Natural hydroponics? What are the plants?
Zinnias, marigolds, sunflowers, and a few randos.
Unless you’re securing the sections together beyond the interlocking bits I’d expect to eventually run into a scenario where everything breaks apart too.
Any plans for an improved version?
I’m sure there will be a lot of small improvements over time…I already added weights to the corners, and will probably try some design ideas from a link suggested from the original thread.
Hope it works better this time around!
Nooooo!
That seemed inevitable considering how light that material is . You expected that, but just hoped for the best nonetheless?