At least so far. The first go round had the nozzle crash into the tree support, resulting in a layer shift. The good news is that the print stayed very firmly stuck to the bed.

I’ve reset, lowered my extrusion multiplier a smidge, switched to a more traditional support pattern, and am going for it again. Wish me luck!

  • 𝒍𝒆𝒎𝒂𝒏𝒏@lemmy.dbzer0.comEnglish
    2·
    6 个月前

    I’m looking into printing with ASA eventually - have you tried skirts on an ASA print? (Not sure what other slicers call it - it’s a wall that is printed around the print to shield drafts)

    I don’t have an enclosure on my delta so was considering that as an alternative.

    • IMALlama@lemmy.worldOPEnglish
      2·
      6 个月前

      Yes, I’ve done skirts. At a certain print size/aspect ratio it doesn’t really matter though - the parts are going to want to warp without a warm enclosure. If you have great first layer adhesion it will just take your build plate with it. You’ll find a picture of that happening on this printer if you look through my post history.

      Smaller parts in x/y and round corners will help prevent warping.

      I printed all the parts for my Voron using an i3 clone under a cardboard box. I doubt that “chamber” got very warm, but it was enough for success.