I forgot to put back the metal plate on my Anycubic Kobra 2 and pressed print. Managed to stop it relatively quickly but still damaged the heating surface a bit and it chipped away some of the material as you can see. How fucked am I?
I forgot to put back the metal plate on my Anycubic Kobra 2 and pressed print. Managed to stop it relatively quickly but still damaged the heating surface a bit and it chipped away some of the material as you can see. How fucked am I?
I would say like 10% fucked… you need to get a knife and cut the edges of that hole at an angle so the print mat will sit flat on it again. Then you just print. The hole isn’t small but also not that big of a deal.