​

My cpu is running on 15 degrees!

So… very heavy rosewill L4500U, fully loaded with 15 HDDs is apparently very heavy.

Very heavy enough to destroy the istarUSA rails that I got for it. These rails always lead to me having to push and pull to be able to pull the chassis out, so i hated them anyways. The problem is that the official rosewill ones suck, and i don’t know what rails you can use.

I accidentally pushed down for one second on the end while trying to remove the top cover… and now i have bearing balls everywhere in my closed rack. Life is good! Any suggestions on better rails?

  • SpencerXZX@alien.topBEnglish
    1·
    1 year ago

    I’ve seen some bad rails and some very good ones. The SuperMicro 4U sliding rails are built like a tank. In the past I’ve stacked 3 loaded 4U chassis on top of a server with SuperMicro rails and it held it like a champ. Don’t worry, I installed rails in them eventually. Having them stacked made it impossible to service any of them but the top one. The Silverstone rails I have are “OK” but not great. I would trust them not to just break but I’m not going to be server stacking.

    • CoderStone@alien.topOPBEnglish
      1·
      1 year ago

      agreed, the ones holding my CSE846 are SO good, if only they were rosewill compatible.

    • wewefe@alien.topBEnglish
      1·
      1 year ago

      Are these supermicro ones tool less? I hate trying to install the istarusa rails because the rear screws are impossible to get at if you have ZeroU PDUs installed. The best rails i have used are the tool less CIsco UCSC-RAILB-M4, it takes a total of 30 seconds to install a server in a bare rack.