I feel like it shouldn’t be possible to have filament oozing out through the thermister port/cartridge slot.
either it’s a funky design, or something is very wrong- OP… were you printing with red filament? The other thought I had was some sort of adhesive or thermal paste (which… is a bad idea. Most thermal paste decomposes at printing temps… but I’ve never seen red thermal paste.)
Looking again, I feel like it’s NOT coming through the thermistor, it’s probably coming through the heat break and just dripping down onto the thermistor. That’s pretty common when your bowden tube isn’t seated properly. Either way, the thing to do is disassemble, clean, re-assemble. Probably put in a fresh bowden tube, too.
I feel like it shouldn’t be possible to have filament oozing out through the thermister port/cartridge slot.
either it’s a funky design, or something is very wrong- OP… were you printing with red filament? The other thought I had was some sort of adhesive or thermal paste (which… is a bad idea. Most thermal paste decomposes at printing temps… but I’ve never seen red thermal paste.)
Looking again, I feel like it’s NOT coming through the thermistor, it’s probably coming through the heat break and just dripping down onto the thermistor. That’s pretty common when your bowden tube isn’t seated properly. Either way, the thing to do is disassemble, clean, re-assemble. Probably put in a fresh bowden tube, too.
That’s it precisely