I think that the additional weight on the water on the surface of the outer airplane body increases friction with the air, and also weight of the aircraft. But does the fuel consumption increase? And by how much?

  • traches@sh.itjust.works
    link
    fedilink
    English
    arrow-up
    50
    ·
    edit-2
    1 year ago

    Former C-130 Flight engineer here, it was my job to calculate performance data for takeoff and landing.

    Rain only matters because it increases stopping distance. It doesn’t affect engine performance, and it never even occurred to me that a wet airplane would be heavier than a dry one. To get a sense of weights we care about, our empty weight is ~90k pounds and our max (peacetime) takeoff weight is 155k pounds. Performance numbers are good for 5000 pounds, so even if the water weighs several hundred pounds we’d never notice.

    The most important factor in engine performance is the density of the air, which is driven by temperature and altitude. You get more power on cold days and at low altitude, less on hot days and high altitudes. (Which is why Denver has long runways)

    There is a decision tree when planning a takeoff, and extended stopping distances due to a wet runway sometimes pushes you to use a higher power setting which is a bit less efficient. So the answer to your question is maybe a little, sometimes, but not in the way you think.

    • wolfpack86@lemmy.world
      link
      fedilink
      arrow-up
      3
      ·
      1 year ago

      Rainy days will lower barometric pressure, so perhaps there’s a performance drop, but not by virtue of the water on the plane?

      • traches@sh.itjust.works
        link
        fedilink
        English
        arrow-up
        4
        ·
        edit-2
        1 year ago

        We do account for barometric pressure, but it’s generally a few tens of feet. So yeah, a teeny tiny bit, though you can have low barometric pressure without rain.

  • subversive_dev
    link
    fedilink
    arrow-up
    13
    ·
    1 year ago

    Total guess but I imagine the increase in relative humidity impacts the combustion efficiency of the engine as well

  • originalfrozenbanana@lemm.ee
    link
    fedilink
    English
    arrow-up
    4
    arrow-down
    2
    ·
    edit-2
    1 year ago

    If you consider the fuselage a cylinder and calculate the surface area of the lateral surface it’s 2pir*h. this site has the length as 209.08ft and the diameter as 20.3. That means the fuselage surface area is about 13300ft^2. That same site lists the wing surface area as 4605ft^2, for a total of 17905 square. Assuming an 1/8” of water accumulates uniformly, which is a bad assumption, that’s 2238 cubic feet of water. Each cubic foot weighs about 62 pounds, so that much water weighs 136000 pounds. The normal takeoff weight of a 777 is 534000 pounds, yeah that is a lot. However, only about half the surface area is exposed to rain and 1/8 inch is a lot. Id imagine it’s less than half that weight.

  • GregorGizeh@lemmy.world
    link
    fedilink
    arrow-up
    2
    arrow-down
    1
    ·
    1 year ago

    I don’t know much about it myself, but I would guess it is negligible. Maybe for small propeller machines with a fairly limited amount of fuel capacity; but larger planes, especially commercial ones, have reserve fuel for quite some time.

    Situations where landing at the destination is temporarily unavailable, air traffic requires the plane to circle for some time, or they are even rerouted to a different airport can always occur and are accounted for. A minor increase from rainfall shouldn’t make a dent. I would think.