I’ve printed about 40 rolls of iiidmax PLA+ and have encountered bulges like these before. I thought it was just bad luck but I think I’m done now. Going to try to finish the 10 rolls I still have left and find a new brand.

  • GodzillaSpark@lemmy.worldOP
    link
    fedilink
    English
    arrow-up
    5
    ·
    1 year ago

    It’s the cheapest PLA that I could find at about $10 / roll, made in the USA, ships pretty quickly, and nearly all rolls print without issue. But this is the second time I’ve seen a bulge like this, so it’s not bad luck. There’s some quality control issues.

    • ScottE@lemmy.world
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 year ago

      I would contact their customer support, it’s likely they’ll send you a new roll, and hopefully it will help them improve quality knowing they shipped some bad ones.

    • ScottE@lemmy.world
      link
      fedilink
      English
      arrow-up
      2
      arrow-down
      2
      ·
      1 year ago

      I would contact their customer support, is likely they’ll send you a new roll, and hopefully it will help them improve quality knowing they shipped some bad ones.

    • ScottE@lemmy.world
      link
      fedilink
      English
      arrow-up
      0
      ·
      1 year ago

      I would contact their customer support, it’s likely they’ll send you a new roll, and hopefully it will help them improve quality knowing they shipped some bad ones.