I changed the strings on my Jackson Dinky JS11. Normally I use light gauge, but this time I went with medium. After tuning it and noticing the difference in thickness, the bridge is on a sharp angle, and the whammy bar couldn’t even swivel past the volume knob.

I tried loosening the two bridge screws which helped a bit and raised it to be less sharp of an angle, but it also raised the action considerably. At least the whammy bar can swivel freely. But the amount I can “wham” seems less than before, too. (Pictures are after this adjustment)

Is there a way to get the back end of the bridge downward so it is more “even”? That would reduce some of the action and give me more whammy room?

  • eezeebee@lemmy.caOP
    link
    fedilink
    English
    arrow-up
    1
    ·
    1 year ago

    I figured it was the strings causing it. Here’s a pic of the bridge screws I’m referring to. Thanks

        • eezeebee@lemmy.caOP
          link
          fedilink
          English
          arrow-up
          1
          ·
          1 year ago

          Honestly I’ve had these laying around for over a year. It’s quite possible they were meant for my acoustic, but I don’t remember. I seem to recall acoustic string packs saying so in the past. Also possible I’m an idiot (the evidence is mounting)

      • eezeebee@lemmy.caOP
        link
        fedilink
        English
        arrow-up
        1
        ·
        1 year ago

        These. And yeah I found that odd, too. If this is medium I would hate to try heavy.

        • DarkInspiration@lemmy.world
          link
          fedilink
          English
          arrow-up
          3
          ·
          1 year ago

          It’s medium, for jazz

          13s on your dinky might be a little too much if you want to play on E standard.

          Pretty decent if you want to play in C ou D Standard, though

    • DarkInspiration@lemmy.world
      link
      fedilink
      English
      arrow-up
      2
      ·
      1 year ago

      So… Those are not the right screws to turn in that situation… And that’s why your action is super high.

      I’d recommend you screw them down as they were before, not all the way down! Else the bridge won’t be able to pivot.

    • kiwifoxtrot@lemmy.world
      link
      fedilink
      English
      arrow-up
      2
      ·
      1 year ago

      Those aren’t the screws you need to tighten! You need to flip the guitar over, take the back plate off, and adjust the screws in the cavity. You should only adjust those with the string tension off. Send us a picture before you do anything.

      • eezeebee@lemmy.caOP
        link
        fedilink
        English
        arrow-up
        2
        ·
        edit-2
        1 year ago

        Youtube told me they were, but yeah I agree they aren’t correct for my problem. PS I loosened them because after putting on the new strings and tuning, the bridge was sharply pointed downward toward the pickups, almost digging into the body.

        I did take off the back plate and tightened the two screws attached to the spring mechanism, as tight as they would go without stripping. That didn’t make too much of a difference unfortunately.

          • eezeebee@lemmy.caOP
            link
            fedilink
            English
            arrow-up
            1
            ·
            1 year ago

            That seems like the root cause of this issue. I’ll try downtuning and see if I can live with it that way before resorting to changing strings again. Thanks for your help