Printed this model recently, it took 60 hours! 7 colors (8 including support filament) on Bambu X1C with 2x AMS. 0.1mm layer height, every single layer had like at least 3 color changes.
If I had to do it again I probably wouldn’t do it multicolor lol - single-color test prints only took about 6 hours.
Thank you! I was having spool jams a few times during the day, so I was a little freaked each time I went to bed - thankfully, no jams at night 🙌
I also wish the resolution on his head/face was a little better, especially at 0.1, but with how many color changes per layer the whole piece took I’m not surprised.
I’m also pretty sure I could’ve sped the print up a bit with a faster infill speed, but with all the color changes on every single layer it probably wouldn’t have mattered much.