With this particular model, Prusaslicer is very optimistic about bridging and support generation:

  1. the right side (dark blue) has no support that could help with load-bearing
  2. the entire layer will be connected to those two lines
  3. more than 5cm long bridges

I don’t think this gcode will successfully print.

How do fix adjust the cura setting to generate a printable output?

The model in question is: https://www.delta-fan.com/Download/3D/BUB0612HJ-00.stp

  • EmilieEvansOPEnglish
    2·
    8 months ago

    Fill angle didn’t change this as Prusaslicer sees this as a bridge.

    Bridges will be printed using the best direction PrusaSlicer can detect, so this setting does not affect them.

    https://help.prusa3d.com/article/infill_42#fill-angle

    edit: just saw that there is a bridge angle setting that sets a fixed angle for every bridge.