Hey there, first post – hope it’s okay to put out a request for some advice. I just started 3D printing a few weeks ago (got an Ender 3 S1) and contrary to seemingly everyone else online, I’ve had no issues whatsoever with bed adhesion, rather the opposite.

Mostly to this point, I’ve been using ‘EconoFil’ PLA from filaments.ca (which was tricky to remove until I bought a better bed spatula-thing). Yesterday I got a roll of Overture ‘Eco-PLA’, which I’ve printed with a couple of times using organic supports, and both times has left a really stuck-on, almost chalky layer of filament on the bed. This isn’t so bad if I’m printing with the same filament afterward, but the Eco-PLA is ‘Midnight Black’ and I want to switch back to the Econofil for another model, which is ‘Bone White’ and I don’t want the bottom to get stained with the leftover Eco-PLA.

Has anyone had any similar issues? Any foolproof technique for removing stubborn, very thin layers?

  • chkno
    link
    fedilink
    English
    arrow-up
    4
    ·
    1 year ago

    As a bed scraper, I use a putty knife that I’ve sharpened on one side (chisel grind, #4).

    Before printing too-sticky materials (like TPU on my PEI bed), I put down a layer of glue stick. This is sticky enough for successful prints, but easily removed at the end of the print.

      • chkno
        link
        fedilink
        English
        arrow-up
        1
        ·
        1 year ago

        Not as long as I’m careful to keep the the blade flat against the bed. The corners would likely gouge if I applied force with only the corner touching the bed, so I don’t do that.

        I suppose the corners would gouge if the tool was treated roughly & the corners were to become bent such that they no longer lined up perfectly with the rest of the blade, so I don’t do that either.

        :)

    • JohnEdwa@kbin.social
      link
      fedilink
      arrow-up
      1
      ·
      1 year ago

      As an extra hint, if you have a sticky print don’t try to smash and stab the putty knife at it, instead grab a hammer/wrench/anything really and gently tap it under the print. It releases so, so much easier.