Hi folks!

I have a old HP desktop that I have set up with Proxmox, and I have a Debian vm running on it that I would like to access through FTP. I have set up vsftpd and it works well on the internal network, but would like to set it up so it is available on any network. I have a static IP.

Because of how my network setup is I am having some problems, and hope someone here might have some guidance.

I have a UniFi UXG-PRO. This is set up behind a TP link router and the ISP router (not optimal I know). This was done since the UXG could not get online directly behind the ISP router due to reasons only the ISP knows and refuses to tell me.

Within the ISP router I have set up port forwarding to the UXG, and in the UXG I have port forwarding to the ftp server. Is this the correct way to do this within my setup?

The ISP and UXG router are both on x.x.1.x, and the TPLink is on x.x.0.x if it matters. I am not able to reach the server from the ISP router network, only the UXG, even with port forwarding enabled. Firewall on the server is set to allow ftp connections on port 21

  • SpacePirateEnglish
    1·
    1 year ago

    Not sure of your level of routing knowledge, but assuming you don’t know, just setting your UXG to 10.0.1.0/32 will not make it the “same” network as your ISP router— it will try to create a new network in the same address space, unless you specifically set it to bridge/switch mode/disable routing/creating a network. And if you do this behind the TP link, you would need to create a static route to span the networks, but I don’t think this is what you are trying to do.

    I think your issue with the UXG not working on your ISP router’s network directly is that both your ISP router and the UXG are creating/acting as the “gateway” on 10.0.1.1, resulting in a collision. Set the UXG to run as a bridge, or create a different network (10.0.2.0/32) while operating on the ISP subnet (10.0.1.0/32).