I’m thinking of building a new printer and would love to be able to make 2 color prints or dissolvable supports. Does anyone have any experience with this. I see 3 paths.

  1. Two hot ends Pros: Most robust No retraction or filament waste Cons: Alignment issues. Reduced travel Dragging nozzle

  2. Dual filament hot end(taichi style) Pros: Easy to mount No offsets Cons: Jamming? Long retraction

  3. Y splitter Pros: easy to mount No offset Compatible with any hot end Cons jamming Super long retraction

  • EmilieEvansEnglish
    3·
    10 months ago

    1 (Two hotends): Can be difficult to setup. Requires raising/lowering and ooze shield to lift and block the nozzle. Very reliable and no purging. My recommendation.

    2 (dual filament hot end): Easier than option 3 but getting it reliable might be challenging and adds the constrain of filament cooking (requires extrusion of both frequently during the print or the filament/hotend will be damaged)

    3 (y splitter): Requires a high-quality y-splitter and perfect setup. Very difficult to nail it reliably. Not recommended if it can be avoided.

    more options:

    1. ERCF/MMU/AMS: Overkill for 2 materials and purge block required. Setup is as bad as two hotends.

    2. Toolchanger: Overkill for this. There are applications where they shine but for this general task they are expensive overkill.

    3. Mosaic pallet. Interesting option but expensive. No printer modification required.

      • EmilieEvansEnglish
        1·
        10 months ago

        2 is mixing hotends. What you describe is 3 (y-splitter with the splitting integrated into the heat sink). They suffer basically the same issues like an “external” y-splitter. You can get them to work but changing materials requires you to do all of the painful setup/calibration once more.

        .

        That they don’t have oozing issues is correct but I never mentioned this in the first place.

        .

        The main issue with 2 (mixing) is cooking the filament and slicers aren’t great at this (operational challenge). There are more pro and cons but I think in the end it boils down to two applications: 1. cheap to integrate. 2. While they are advertised as mixing hotend the result is on pair with dual color/extrusion filament.